Datasheet

CUSTOMER RELEASE NOTES
6/03/2010 P/N: 9038247-01 Subject to Change Without Notice Page: 4 of 13
F0615-O
Product Features
STP Loop Protect
L2 Policy Rules
LLDP/LLDP-MED with TLVs
COS based Inbound Rate Limiter per Policy User
Legacy Path Cost
DHCP Server
STP Pass Through
Web Authentication (PWA)
SpanGuard
Web Redirect – PWA+ and URL redirection
Link Flap Detection
802.1X Authentication
Per Port Broadcast Suppression
Non-Strict 802.1X Default RFC 3580 With Auth Failure
Port Mirroring
RADIUS Client
Protected Port (Private VLAN)
Turn Off RADIUS Authentication (RADIUS Realm)
Cabletron Discovery Protocol (CDP)
Queuing Control Strict and Weighted Round Robin
Cisco Discovery Protocol (CDP) v1/2
MAC Authentication / MAC Authentication Masking
Cisco IP Phone Discovery
MAC Authentication Retained After Age Out
GVRP
RADIUS Accounting for MAC Authentication
IGMP v1/v2/v3 Snooping
EAP Pass Through
Syslog
VLAN marking of mirrored traffic – Edge only
Text-based Configuration Upload/Download
Dynamic and Static MAC Locking
CLI Management
New Mac Trap (like the Matrix-E1)
Telnet Support
Dynamic Egress
IPv4/IPv6 Dual Host Management Support
SSHv2
Discard VLAN Tagged Frames
WebView
Jumbo Frame (up to 9K)
SSL Interface to WebView
Priority Classification L3-L4
RMON (4 groups)
VLAN-to-Policy Mapping on a per Port Basis
RMON View in the CLI With Persistent Sets
Node/Alias Table
RMON Packet Capture/Filtering Sampling
ToS Rewrite
SNMPv1, SNMPv2c, SNMPv3
IPv4/IPv6 Routing
Simple Network Time Protocol (SNTP)
Multiple IP Helpers per Interface (up to 6)
Alias Port Naming
ACLs
Ability to Set Time and Date via the MIB
IPv4 Routing Protocols: RIP, OSPF, VRRP, DVMRP,
IRDP, PIM-SM
CoS MIB based Flood Control (broadcast, multicast,
and unknown unicast)
IPv6 Routing Protocols: OSPFv3
CPU/Memory utilization monitoring via SNMP
IPV6 Tunneling
SMON MIB support for Port Mirroring
INSTALLATION AND CONFIGURATION NOTES:
Note:
As a best practice, Enterasys recommends that prior to upgrading the firmware on your switch, you save the
existing working configuration of the system by using the show config outfile configs/<filename> command.
Please go to http://www.enterasys.com/download/download.cgi?lib=c5 for the latest firmware updates for the C5
Series. If you would like to upgrade an existing C5, follow the TFTP download instructions that are included in
your CLI Reference or use NMS Inventory Manager to upgrade the switch.
TFTP download instructions are also available under the Hot Topics list on the Enterasys support web site at:
https://knowledgebase-enterasys.talismaonline.com