Switch User Manual

Starting and Configuring Telnet
SecureStack C3 Configuration Guide 3-37
Starting and Configuring Telnet
Purpose
ToenableordisableTelnet,andtostartaTelnetsessiontoaremotehost.TheSecureStackC3
switchallowsatotaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Commands
show telnet
UsethiscommandtodisplaythestatusofTelnetontheswitch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayTelnetstatus:
C3(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
UsethiscommandtoenableordisableTelnetontheswitch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
For information about... Refer to page...
show telnet 3-37
set telnet 3-37
telnet 3-38