Switch User Manual

set boot system
3-36 Basic Configuration
set boot system
Usethiscommandtosetthefirmwareimagetheswitchloadsatstartup.
Syntax
set boot system filename
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thiscommandallowsyoutosetthefirmwareimagetobeloadedatstartup.Youcanchooseto
resetthesystemtousethenewfirmwareimageimmediately,oryoucanchoosetoonlyspecifythe
newimagetobeloadedthenexttimetheswitchisrebooted.
Youcanuse
thedircommandtodisplaythe“A c t i v e ” imageandthe“Boot”image,whichwillbe
theimageloadedatthenextsystemreboot.
Example
Thisexampleshowshowtosetthebootfirmwareimagefiletobeusedatthenextrebootofthe
system,byanswering“n”totheprompt.ThedircommandisthenexecutedtodisplaytheActive
andBootimages.
C3(su)->set boot system c3_06.03.03.0007
This command can optionally reset the system to boot the new image.
Do you want to reset now (y/n) [n]?n
C3(su)->dir
Images:
==================================================================
Filename: c3_06.03.00.0026 (Active)
Version: 06.03.00.0026
Size: 9405440 (bytes)
Date: Fri Jul 18 12:48:35 2008
CheckSum: f1626ccf10d8f48cd6c3e79ab602342a
Compatibility: <platform specific>
Filename: c3_06.03.03.0007 (Boot)
Version: 06.03.03.0007
Size: 8290304 (bytes)
Date: Fri May 9 11:35:27 2008
CheckSum: 9f820d79239f10890442f8ff1f2bc914
Compatibility: <platform specific>
filename Specif iesthenameofthefirmwareimagefile.
Note: If you are changing the firmware image to a version earlier than the current version, refer to
“Reverting to a Previous Image” on page 3-34 for the correct steps to follow.