Switch User Manual

set sflow receiver port sFlow Configuration
SecureStack C3 Configuration Guide 28-9
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthemaximumdatagramsizeto2800bytesforindexentry1.
C3(su)->set sflow receiver 1 maxdatagram 2800
set sflow receiver port
UsethiscommandtoconfiguretheUDPportonthesFlowControllertowhichtheswitchwill
sendsampledatagrams.
Syntax
set sflow receiver index port port
Parameters
Defaults
Thedefaultportvalueis6343.
Mode
Switchcommand,read‐write.
Example
ThisexamplechangesthesFlowreceiverportontheCollectorto1234.
C3(su)->set sflow receiver 1 port 1234
clear sflow receiver
Usethiscommandtodeleteareceiver/CollectorfromthesFlowReceiversTable,ortoreturn
certainparameterstotheirdefaultvaluesforthespecifiedCollector.
Syntax
clear sflow receiver index [ip | maxdatagram | owner [timeout] | port]
Parameters
index IndexnumberinthesFlowReceiversTableforthereceiver/Collector
beingconfigured.Theindexcanrangefrom1to8.
portport SpecifiestheUDPportonthereceiver/Collectortowhichthesample
datagramsshouldbe sent.Bydefault,theportis6343.
index IndexnumberinthesFlowReceiversTableforthereceiver/Collector
beingconfigured.Theindexcanrangefrom1to8.
ip (Optional)CleartheIPaddressto0.0.0.0.Sampledatagramsarenotsent
toCollectorswithanIPaddressof0.0.0.0.
maxdatagram (Op tional)Returnthemaximumdatagramsizeto1400bytes.