Switch User Manual

show tacacs interface TACACS+ Configuration
SecureStack C3 Configuration Guide 27-11
Defaults
None.
Mode
Switchcommand,Read‐Write.
Examples
Thisexampleshowshowtodisablesendingmultiplerequestsoverasingleconnection.
C3(rw)->set tacacs singleconnect disable
show tacacs interface
UsethiscommandtodisplaytheinterfaceusedforthesourceIPaddressoftheTACACS+packets
generatedbytheswitch.
Syntax
show tacacs interface
Parameters
None.
Defaults
None.
Mode
Switchmode,read‐only.
Example
Thisexampledisplaystheoutputofthiscommand.Inthiscase,theIPaddressassignedto
loopbackinterface1willbeusedasthe sourceIPaddressoftheTACACS+packetsgeneratedby
theswitch.
C3(rw)->show tacacs interface
loopback 1 192.168.10.1
set tacacs interface
UsethiscommandtospecifytheinterfaceusedforthesourceIPaddressoftheTACACS+packets
generatedbytheswitch.
Syntax
set tacacs interface {loopback loop-ID | vlan vlan-ID}
Parameters
loopbackloop‐ID Specifiestheloopbackinterfacetobeused.Thevalueofloop‐IDcan
rangefrom0to7.