Switch User Manual

clear policy maptable
26-56 Authentication and Authorization Configuration
Defaults
Nomappingtableentriesareconfigured.
Thedefaultpolicymaptableresponsesettingispolicymode.
Mode
Switchcommand,read‐write.
Usage
ThiscommandcanbeusedtocreateentriesintheVLAN‐to‐policymappingtableandalsotoset
theswitch’smaptableresponse.Referto“OperationalDescription”onpage 26 ‐53formore
informationabouttheswitch’soperationsforallmaptableresponseparameters.
WhenyouareusingVLANauthorizationfordynamic
VLANassignment,youshouldsetthe
policymaptableresponsetotunnel.See“ConfiguringVLANAuthorization(RFC3580)”on
page 26‐49.
Examples
Thisexampleshowshowtosetthepolicymaptableresponsetoboth,orhybridauthentication
mode:
C3(rw)->set policy maptable response both
ThisexampleshowshowtoconfigureapolicymappingentrythatwillmapVLAN144topolicy
profile4.
C3(rw)->set policy maptable 144 4
clear policy maptable
UsethiscommandtoclearaVLAN‐to‐policymappingtableentryortoresetthemaptable
responsetothedefaultvalueofpolicymode.
Syntax
clear policy maptable {vlan-list | response}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThiscommandcanbeusedtoremoveanentryintheVLAN‐to‐policymappingtableortochange
themaptableresponsebacktothedefaultvalueofpolicymode.
vlan‐list ClearsthepolicyprofilemappingforthespecifiedVLANIDorrangeof
VLANs.
response Resetsthemaptableresponsetopolicy
.