Switch User Manual

set system enhancedbuffermode
3-18 Basic Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisplayenhancedbuffermodestatus:
C3(su)->show system enhancedbuffermode enable
Optimized system buffer distribution Disable
set system enhancedbuffermode
Usethiscommandtoenableordisableenhancedbuffermode,whichoptimizesbuffer
distributionintoasingleCoSqueueoperationforstandaloneswitchesornon‐stackedswitches.
Executingthiscommandwillresettheswitch,sothesystempromptsyoutoconfirmwhetheryou
wanttoproceed.
Syntax
set system enhancedbuffermode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoenableenhancedbuffermode:
C3(su)->set system enhancedbuffermode enable
Changes in the enhanced buffer mode will require resetting this unit.
Are you sure you want to continue? (y/n)
set system temperature
Usethiscommandtosetthesystemhightemperaturethresholdlimitandthehightemperatu re
alertparameters,ontheplatformsthatsupportthisfeature.
Syntax
set system temperature {[syslog enable | disable] [trap enable | disable]
[overtemp-threshold value]}
enable|disable Enablesordisablesenhancedbuffermode.