Switch User Manual

clear system utilization
SecureStack C3 Configuration Guide 3-17
C3(rw)->set system utilization threshold 750
clear system utilization
UsethiscommandtoresettheCPUutilizationthresholdtothedefaultof80%.
Syntax
clear system utilization
Parameters
None.
Defaults
Thedefaultthresholdvalueis80%.
Mode
Switchcommand,read‐write.
Example
ThisexampleresetstheCPUutilizationthresholdtothedefault.
C3(rw)->show system utilization cpu
CPU Utilization Threshold Traps enable: Threshold = 75.0%
Total CPU Utilization:
Switch CPU 5 sec 1 min 5 min
-------------------------------------------------
1 1 10% 10% 10%
C3(rw)->clear system utilization
C3(rw)->show system utilization cpu
CPU Utilization Threshold Traps enable: Threshold = 80.0%
Total CPU Utilization:
Switch CPU 5 sec 1 min 5 min
-------------------------------------------------
1 1 14% 11% 10%
show system enhancedbuffermode
Usethiscommandtodisplaythestatusofenhancedbuffermode,whichoptimizesbuffer
distributionintoasingleCoSqueueoperationforstandaloneswitchesornon‐stackedswitches.
Syntax
show system enhancedbuffermode
Parameters
None.