Switch User Manual

set multiauth mode
SecureStack C3 Configuration Guide 26-39
set multiauth mode
Usethiscommandtosetthesystemauthenticationmodetoallowmultipleauthenticators
simultaneously(802.1x,PWA,andMACAuthentication)onasingleport,ortostrictlyadhereto
802.1xauthenticati on.
Syntax
set multiauth mode {multi | strict}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
MultiauthmultimoderequiresthatMAC,PWA,and802.1Xauthenticationbeenabledglobally,
andconfiguredappropriatelyonthedesiredportsaccordingtotheircorrespondingcommand
setsdescribedinthischapter.Referto“Configuring802.1XAuthentication” onpage 26‐15and
“ConfiguringMACAuthentication”onpage 26‐25and“ConfiguringPort
WebAuthentication
(PWA)”onpage 26‐68.
Example
Thisexampleshowshowtoenablesimultaneousmultipleauthentications:
C3(rw)->set multiauth mode multi
clear multiauth mode
Usethiscommandtoclearthesystemauthenticationmode.
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
multi Allowsthesystemtousemultipleau thenticatorssimultaneously(802.1x,
PWA,andMACAuthentication)onaport.Thisisthedefaultmode.
strict Usermustauthenticateusing802.1xauthenticationbeforenormaltraffic
(anythingotherthanauthenticationtraffic)canbeforwarded.