Switch User Manual

show eapol
SecureStack C3 Configuration Guide 26-21
Thisexampleshowshowtoresetthe802.1Xquietperiodto60secondsonportsge.1.1‐3:
C3(su)->clear dot1x auth-config quietperiod ge.1.1-3
show eapol
UsethiscommandtodisplayEAPOLstatusorsettingsforoneormoreports.
Syntax
show eapol [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,onlyEAPOLenablestatuswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayEAPOLstatusforportsge.1.1‐3:
C3(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
ge.1.1 Initialize Auto
ge.1.2 Initialize Auto
ge.1.3 Initialize Auto
Table 26‐2providesanexplanationofthecommandoutput.For detailsonusingtheseteapol
commandtoenabletheprotocolandassignanauthenticationmode,referto“seteapol”on
page 26‐23.
port‐string (Optional)DisplaysEAPOLstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsed
intheCLI”onpage 7‐1.