Switch User Manual

clear radius interface
SecureStack C3 Configuration Guide 26-13
Mode
Switchcommand,read‐write.
Usage
ThiscommandallowsyoutoconfigurethesourceIPaddressusedforthesourceIPaddressofthe
RADIUSapplicationwhengeneratingRADIUSpackets.Anyofthemanagementinterfaces,
includingVLANroutinginterfaces,canbeconfiguredasthesourceIPaddressusedinpackets
generatedbytheRADIUS application.
Aninterface
musthaveanIPaddressassignedtoitbeforeitcanbesetbythiscomm and.
Ifnointerfaceisspecified,thentheIPaddressoftheHostinterface,ifconfigured,willbeusedfor
boththesourceIPaddressandNAS‐IP.Ifnoint erfaceisspecifiedandnoHost
addressis
configured,thesourceIPaddresswillbe theaddressoftheroutedinterfaceonwhichthepacket
egresses.Ifloopback0hasbeenconfigured,theNAS‐IPwillbesettotheIPaddressofloopback0.
Otherwise,theNAS‐IPwillbezero.
Example
ThisexampleconfiguresanIPaddressonVLANinterface100andthensetsthatinterfaceasthe
RADIUSapplicationsourceIPaddress.
C3(rw)->router(Config-if(Vlan 100))#ip address 192.168.10.1 255.255.255.0
C3(rw)->router(Config-if(Vlan 100))#exit
C3(rw)->router(Config)#exit
C3(rw)->router#exit
C3(rw)->router>exit
C3(rw)->set radius interface vlan 100
C3(rw)->show radius interface
vlan 100 192.168.10.1
clear radius interface
UsethiscommandtocleartheinterfaceusedforthesourceIPaddressoftheRADIUSapplication
backtothedefaultoftheHostinterface,ifconfigured.IfnoHostaddressisconfigured,thesource
IPaddresswillbetheaddressoftheroutedinterfaceonwhichthepacketegresses.
Syntax
clear radius interface
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.