Switch User Manual

show radius interface
26-12 Authentication and Authorization Configuration
Defaults
None.
Example
ThisexampleshowshowtoresettheRADIUSaccountingtimeoutto5seconds.
C3(su)->clear radius accounting timeout
show radius interface
Usethiscommandtodisplaytheint erfaceusedforthesourceIPaddressoftheRADIUS
applicationwhengeneratingRADIUSpackets.
Syntax
show radius interface
Parameters
None.
Defaults
None.
Mode
Switchmode,read‐only.
Example
Thisexampledisplaystheoutputofthiscommand.Inthiscase,theIPaddressassignedto
loopbackinterface1willbeusedasthe sourceIPaddressoftheRADIUSapplication.
C3(rw)->show radius interface
loopback 1 192.168.10.1
set radius interface
UsethiscommandtospecifytheinterfaceusedforthesourceIPaddressoftheRADIUS
applicationwhengeneratingRADIUSpackets.
Syntax
set radius interface {loopback loop-ID | vlan vlan-ID}
Parameters
Defaults
None.
loopbackloop‐ID Specifiestheloopbackinterfacetobeused.Thevalueofloop‐IDcan
rangefrom0to7.
vlanvlan‐ID SpecifiestheVLANinterfacetobeused.Thevalueofvlan‐IDcanrange
from1to4093.