Switch User Manual

Configuring RADIUS
26-6 Authentication and Authorization Configuration
Configuring RADIUS
Purpose
Toperformthefollowing:
•ReviewtheRADIUSclient/serverconfigurationontheswitch.
•EnableordisabletheRADIUSclient.
•Setlocalandremoteloginoptions.
•Setprimaryandsecondaryserverparameters,includingIPaddress,timeoutperiod,
authenticationrealm,andnumberofuserloginattemptsallowed.
•ResetRADIUSserversettingstodefaultvalues.
• ConfigureaRADIUS
accountingserver.
• ConfiguretheinterfaceusedforthesourceIPaddressoftheRADIUSappl icationwhen
generatingRADIUSpackets.
Commands
show radius
UsethiscommandtodisplaythecurrentRADIUSclient/serverconfiguration.
Syntax
show radius [status | retries | timeout | server [index | all]]
Parameters
For information about... Refer to page...
show radius 26-6
set radius 26-7
clear radius 26-9
show radius accounting 26-10
set radius accounting 26-10
clear radius accounting 26-11
show radius interface 26-12
set radius interface 26-12
clear radius interface 26-13
status (Optional)DisplaystheRADIUSserver’senablestatus.
retries (Optional)DisplaysthenumberofretryattemptsbeforetheRADIUSserver
timesout.
timeout (Optional)Displaysthemaximumamountoftime(inseconds)toestablish
contactwiththeRADIUSserverbeforeretryattemptsbegin.