Switch User Manual

show ipv6 ospf virtual-link
25-46 OSPFv3 Configuration
show ipv6 ospf virtual-link
ThiscommanddisplaystheOSPFv3virtualinterfaceinformationforaspecificareaandneighbor.
Syntax
show ipv6 ospf virtual-link areaid neighborid
Parameters
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
ThisinformationdisplaysvirtuallinkinformationforareaID10andtheneighborwithrouterID
of3.3.3.3.
C3(su)->router(Config)#show ipv6 ospf virtual-link 10 3.3.3.3
Area ID 10
Neighbor IP Address 3.3.3.3
Hello Interval 10
Dead Interval 40
Iftransit Delay Interval 1
Retransmit Interval 5
State DOWN
Metric 0
Neighbor State DOWN
Table 25‐13providesanexplanationofthecommandoutput.
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
neighborid SpecifiestheneighborbyitsrouterID,specifiedin32‐bitdottedquad
format.
Table 25-13 show ipv6 ospf virtual-link Output Details
Output Field What It Displays...
Area ID The area id of the requested OSPFv3 area.
Neighbor Router ID The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPFv3 virtual interface.
Dead Interval The configured dead interval for the OSPFv3 virtual interface.
Iftransit Delay Interval The configured transit delay for the OSPFv3 virtual interface.
Retransmit Interval The configured retransmit interval for the OSPFv3 virtual
interface.
State The OSPFv3 Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPFv3 interface.