Switch User Manual

show ipv6 ospf stub table
SecureStack C3 Configuration Guide 25-45
show ipv6 ospf stub table
ThiscommanddisplaystheOSPFv3stubtable,ifOSPFv3isinitializedontheswitch.
Syntax
show ipv6 ospf stub table
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
ThisexampledisplaystheOSPFv3stubtableinformation.
C3(su)->router# show ipv6 ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
---------------- ------------- ---------- -----------------
0.0.0.20 Normal 1 Enable
Table 25‐12providesanexplanationofthecommandoutput.
Table 25-11 show ipv6 ospf range Output Details
Output Field What It Displays...
Area ID The area ID of the requested OSPFv3 area.
IPv6 Prefix/Prefix Length An IPv6 prefix and length which represents a configured area
range.
Lsdb Type The type of link advertisement associated with this area range.
Advertisement The status of the advertisement: enabled or disabled.
Table 25-12 show ipv6 ospf stub table Output Details
Output Field What It Displays...
Area ID A 32-bit identifier for the created stub area.
Type of Service Type of service associated with the stub metric. For this release,
Normal TOS is the only supported type.
Metric Val The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPFv3 cost for a route is a function of the metric
value.
Import Summary LSA Controls the import of summary LSAs into stub areas.