Switch User Manual

show ipv6 ospf interface
SecureStack C3 Configuration Guide 25-39
Authentication Type None
Metric Cost 10 (computed)
OSPF Mtu-ignore Disable
OSPF Interface Type broadcast
State designated-router
Designated Router 2.2.2.2
Backup Designated Router 0.0.0.0
Number of Link Events 2
Thisexampledisplaysinformationabouttunnelinterface0.Table 25‐7onpage 25‐39explainsthe
contentoftheoutputfields.
C3(su)->router#show ipv6 ospf interface tunnel 0
IPv6 Address FE80::5000:2
ifIndex 456
OSPF Admin Mode Enable
OSPF Area ID 0.0.0.0
Router Priority 1
Retransmit Interval 5
Hello Interval 10
Dead Interval 40
LSA Ack Interval 1
Iftransit Delay Interval 1
Authentication Type None
Metric Cost 1 (computed)
OSPF Mtu-ignore Disable
OSPF Interface Type point-to-point
State point-to-point
Designated Router 0.0.0.0
Backup Designated Router 0.0.0.0
Number of Link Events 1
Table 25‐7providesanexplanationofthecommandoutput.
Table 25-7 show ipv6 ospf interface Command Output Details
Output Field What It Displays...
IPv6 Address The IPv6 address of the interface.
ifIndex The interface index number associated with the interface.
OSPF Admin Mode Whether the admin mode is enabled or disabled.
OSPF Area ID The area ID associated with this interface.
Router Priority The router priority. The router priority determines which router is
the designated router.
Retransmit Interval The frequency, in seconds, at which the interface sends LSA.
Hello Interval The frequency, in seconds, at which the interface sends Hello
packets.
Dead Interval The amount of time, in seconds, the interface waits before
assuming a neighbor is down.
LSA Ack Interval The amount of time, in seconds, the interface waits before sending
an LSA acknowledgement after receiving an LSA.
Iftransit Delay Interval The number of seconds the interface adds to the age of LSA
packets before transmission.
Authentication Type The type of authentication the interface performs on LSAs it
receives.