Switch User Manual

show ipv6 ospf interface
25-38 OSPFv3 Configuration
show ipv6 ospf interface
ThiscommanddisplaysinformationaboutOSPFv3interfaces.
Syntax
show ipv6 ospf interface {vlan vlanid | tunnel tunnelid | loopback loopid}
Parameters
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Examples
ThisexampledisplaysinformationaboutOSPFv3routinginterfaceVLAN80.
C3(su)->router>show ipv6 ospf interface vlan 80
IPv6 Address FE80::211:88FF:FE56:5D8F
ifIndex 430
OSPF Admin Mode Enable
OSPF Area ID 0.0.0.20
Router Priority 1
Retransmit Interval 5
Hello Interval 10
Dead Interval 40
LSA Ack Interval 1
Iftransit Delay Interval 1
Link Unknown Total number of link-source unknown LSAs in the OSPFv3 link
state database.
Area Unknown Total number of area unknown LSAs in the OSPFv3 link state
database.
AS Unknown Total number of as unknown LSAs in the OSPFv3 link state
database.
Self Originated Type-7 Total number of self-originated NSSA External Link-State
Advertisements in the OSPFv3 link state database.
Type-5 Ext Total number of AS external LSAs in the OSPFv3 link state
database.
Self-Originated Type-5 Total number of self originated AS external LSAs in the OSPFv3
link state database.
Total Total number of router LSAs in the OSPFv3 link state database.
Table 25-6 show ipv6 ospf database database-summary Output Details (Continued)
Output Field What It Displays...
vlanvlanid SpecifiestheVLANinterfacetodisplayinformationabout.
tunneltunnelid Specifiesthetunnelinterfacetodisplayinformationabout.
loopbackloopid Specifiestheloopbackinterfacetodisplayinformationabout.