Switch User Manual

show ipv6 ospf area
SecureStack C3 Configuration Guide 25-31
show ipv6 ospf area
ThiscommanddisplaysinformationaboutthespecifiedOSPFv3area.
Syntax
show ipv6 ospf area areaid
Parameters
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
ThisexampleshowshowtodisplayOSPFv3informationforarea20.
C3(su)->router>show ipv6 ospf area 20
AreaID 0.0.0.20
External Routing Import NSSAs
Spf Runs 7
Area Border Router Count 0
Area LSA Count 5
Area LSA Checksum 188094
Stub Mode Disable
Table 25‐2 provides an explanation of the command output.
Always Whether default routes are always advertised.
Metric The metric for the advertised default routes. If the metric is not
configured, this field is blank.
Metric Type Whether the routes are External Type 1 or External Type 2.
Table 25-1 show ipv6 ospf Output Details
Output Field What It Displays...
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
Table 25-2 show ipv6 ospf area Output Details
Output Field What It Displays...
AreaID Area ID of the requested OSPFv3 area.
External Routing The external routing capabilities for this area.
Spf Runs Number of times that the intra-area route table has been
calculated using this area's link-state database.
Area Border Router Count Total number of area border routers reachable within this area.
Area LSA Count Total number of link-state advertisements in this area's link-state
database, excluding AS External LSAs.