Switch User Manual

ipv6 ospf dead-interval
SecureStack C3 Configuration Guide 25-23
Parameters
Defaults
Thedefaultcostis10.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(Config‐if(Vlan1))#
Usage
Usethiscommandtoexplicitlyspecifythecostofsendingapacketontheinterfacebeing
configuredforOSPFv3.Usethenoformofthiscommandtoreturnthecosttothedefaultvalueof
10.
Example
ThisexampleconfiguresthecostforrouterinterfaceVLAN7to100.
C3(su)->router(Config)# interface vlan 7
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf cost 100
ipv6 ospf dead-interval
ThiscommandsetstheOSPFv3deadintervalfortherouterinterface.
Syntax
ipv6 ospf dead-interval seconds
no ipv6 ospf dead-interval seconds
Parameters
Defaults
Thedefaultdeadintervalvalueis40seconds.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(Config‐if(Vlan1))#
Usage
TheOSPFv3deadintervalisthelengthoftimeinsecondsthatarouter’sHellopacketshavenot
beenseenbeforeitsneighborroutersdeclarethattherouterisdown.Thevalueforthedead
intervalmustbethesameforallroutersattachedtoacommonnetwork,andshouldbe
some
multipleofthehellointerval.
Usethenoformofthiscommandtoreturnthedeadintervaltothedefaultvalueof40seconds.
cost Specifiesthecostofsendingapacketonthisinterface.Thevaluecan
rangefrom1to65535.
seconds SpecifiestheOSPFv3deadintervalinseconds.Thevaluecanrange
from1to2147483647seconds.