Switch User Manual

Interface Configuration Commands
SecureStack C3 Configuration Guide 25-21
Interface Configuration Commands
Purpose
ThesecommandscanbeusedtoconfigureOSPFv3routinginterfaceparameters.
Commands
ipv6 ospf enable
ThiscommandenablesOSPFv3onarouterinterfaceoraloopbackinterface.
Syntax
ipv6 ospf enable
no ipv6 ospf enable
Parameters
None.
Defaults
OSPFv3isdisabledbydefault.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(Config‐if(Vlan1))#
Usage
UsethiscommandtoenableOSPFv3onarouterVLANinterfaceoronaloopbackinterface.Use
thenoformofthiscommandtodisableOSPFv3onaninterface.
For information about... Refer to page...
ipv6 ospf enable 25-21
ipv6 ospf areaid 25-22
ipv6 ospf cost 25-22
ipv6 ospf dead-interval 25-23
ipv6 ospf hello-interval 25-24
ipv6 ospf mtu-ignore 25-24
ipv6 ospf network 25-25
ipv6 ospf priority 25-26
ipv6 ospf retransmit-interval 25-26
ipv6 ospf transmit-delay 25-27
Note: In order for OSPFv3 to run on an interface, IPv6 must be explicitly enabled on the interface
using the ipv6 enable command.