Switch User Manual

area range
SecureStack C3 Configuration Guide 25-15
Parameters
Defaults
Thedefaultintervalis40seconds.
Mode
RouterOSPFv3configuration:C3(su)->router(Config-router)#
Usage
Thestabilityintervalistheperiodoftimethatanelectedtranslatorcontinuestoperformitsduties
afteritdeterminesthatitstranslatorstatushas beendeposedbyanotherrouter.
Example
Thisexamplesetsthetranslatorstabilityintervalto60secondsforNSSA20.
C3(su)->router(Config-router)# area 20 nssa translator-stab-intv 60
area range
Thiscommandcreatesanaddressrangeforthespeci fiedNSSA.
Syntax
area areaid range ipv6-prefix/prefix-length {summarylink | nssaexternallink}
[advertise | not-advertise]
no area areaid range ipv6-prefix/prefix-length
Parameters
Defaults
Areaaddressrangesarenotconfiguredbydefault.
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
interval Specifiesthestabilityintervalinseconds.Thevalueofintervalcanrange
from0to3600seconds.
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
ipv6‐prefix/prefix‐length SpecifiesIPv6prefixandthelengthoftheIPv6prefixfortheaddress
range.Theprefixmustbespecifiedinhexadecimalusing16‐bitvalues
betweencolons.
Thevalueofprefix‐lengthisa
decimalnumberindicatingthenumberof
high‐ordercontiguousbitsthatcomprisetheprefix.
summarylink SpecifiesthatroutesummarizationshouldbebasedonsummaryLSAs.
nssaexternallink SpecifiesthatroutesummarizationshouldbebasedonexternalLSAs
Type7.
advertise|
not‐advertise
(Optional)Specifieswhetherornottheroutesshouldbeadvertised.If

neitherparameterisspecifies,thedefaultisadvertise.