Switch User Manual

Area Configuration Commands
25-10 OSPFv3 Configuration
Area Configuration Commands
Purpose
Thesecommandsareusedtoconfigureareaparameters.
Commands
area default-cost
Thiscommandconfiguresthedefaultcostforthesummarydefaultroutegeneratedbythearea
borderrouterintothestuborNSSAarea.
Syntax
area areaid default-cost cost
no area areaid default-cost
Parameters
Defaults
None.
For information about... Refer to page...
area default-cost 25-10
area nssa 25-11
area nssa default-info-originate 25-12
area nssa no-redistribute 25-12
area nssa no-summary 25-13
area nssa translator role 25-14
area nssa translator-stab-intv 25-14
area range 25-15
area stub 25-16
area stub no-summary 25-17
area virtual-link 25-17
area virtual-link dead-interval 25-18
area virtual-link hello-interval 25-19
area virtual-link retransmit-interval 25-19
area virtual-link transmit-delay 25-20
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
cost Specifiesacost,whichcanrangebetween1and16777215.