Switch User Manual

DHCPv6 Show Commands
SecureStack C3 Configuration Guide 24-13
DHCPv6 Show Commands
Purpose
ThesecommandsareusedtodisplayDHCPv6configurationinforma tionandstatistics,toclear
statisticsgloballyorforaspecificinterface,andtodisplayaddresspoolandbindinginformation.
Commands
show ipv6 dhcp
ThiscommanddisplaysthestateofDHCPv6ontheswitchand,ifDHCPv6isenabled,the
switch’sDHCPuniqueidentifier(DU ID).
Syntax
show ipv6 dhcp
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
ThisexampleillustratestheoutputofthiscommandwhenDHCPv6isenabledontheswitch.
C3(su)->router# show ipv6 dhcp
DHCPv6 is enabled
Server DUID: 00:01:00:06:90:83:57:c7:00:11:88:56:5d:58
For information about... Refer to page...
show ipv6 dhcp 24-13
show ipv6 dhcp interface 24-14
show ipv6 dhcp statistics 24-16
clear ipv6 dhcp statistics 24-17
show ipv6 dhcp pool 24-18
show ipv6 dhcp binding 24-18