Switch User Manual

Address Pool Configuration Commands
24-6 DHCPv6 Configuration
Address Pool Configuration Commands
Purpose
TheseDHCPpoolconfigurationmodecommandsareusedtoconfigureaddresspoolparameters.
ThisinformationisprovidedtoDHCPclientsbytheDHCPserver.
Commands
domain-name
ThiscommandsetstheDNSdomainnamewhichisprovidedtoDHCPv6clientsbythe DHCPv6
server.
Syntax
domain-name name
no domain-name name
Parameters
Defaults
None.
Mode
RouterDHCPv6poolconfigurationmode:C3(su)‐>router(Config‐dhcp6s‐pool)#
Usage
ADNSdomainnameisconfiguredforstatelessserversupport.ADHCPv6poolcanhaveupto8
domainnamesconfiguredforit.
ThenoformofthiscommandwillremovethedomainnamefromtheDHCPv6poolbeing
configured.
Example
Thisexamplespecifiesthedomainname“enterasys.com”forthepoolnamedPoolA.
C3(su)->router(Config)# ipv6 dhcp pool PoolA
C3(su)->router(Config-dhcp6s-pool)# domain-name enterasys.com
For information about... Refer to page...
domain-name 24-6
dns-server 24-7
prefix-delegation 24-7
exit 24-8
name Specifiesthe DNSdomainnameforthepoolbeingconfigured.The
namecanconsistofnomorethan31alpha‐numericcharacters.