Switch User Manual

ipv6 nd other-config-flag
SecureStack C3 Configuration Guide 22-17
IPv6operation,however,becauseshortertimesconsumemoreIPv6networkbandwidthand
processingresources.
ThisvalueisalsoincludedinallRouterAdvertisementsmessagessentoutontheinterface.By
default,avalueof0,indicatingthattheconfiguredtimeisunspecified bythisrouter,issentoutin
RAmessages.

Usethenoformofthiscommandtoresetthisvaluetothedefault.
Theshowipv6interfacecommanddisplaysthecurrentreachabletimesetting.
Example
Thisexamplesetsthereachabletimeto60seconds.
C3(su)->router(Config-if(Vlan 1))# ipv6 nd reachable-time 60000
ipv6 nd other-config-flag
Thiscommandsetsthe“otherstatefulconfiguration”flaginrouteradvertisementssentonthis
interfacetotrue.
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Parameters
None.
Defaults
Flagissettofalsebydefault.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(Config‐if(Vlan1))#
Usage
Whenthevalueofthe“otherstatefulconfiguration”flagistrue,endnodesshouldusestateful
autoconfiguration(DHCPv6)toobtainadditionalinformation(excludingaddresses).Whenthe
valueisfals e,endnodesdonot.RefertoRFC2462,“IPv6StatelessAddressAutoconfiguration,”
formoreinformation.
Usethenoformofthiscommand
toresettheflagtofalse.
Example
Thisexamplesetstheotherstatefulconfigurationflagtotrue.
C3(su)->router(Config-if(Vlan 1))# ipv6 nd other-config-flag