Switch User Manual

clear switch member
2-12 Configuring Switches in a Stack
Mode
Switchcommand,read‐write.
Usage
Referto“CreatingaVirtualSwitchConfiguration”onpage2‐3formoreinformationabouthowto
addavirtualswitchtoastack.
Example
Thisexampleshowshowtospecifyaswitchasunit1withaswitchIDof1:
C3(su)->set switch member 1 1
clear switch member
Usethiscommandtoremoveamemberentryfromthestack.
Syntax
clear switch member unit
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoremovetheswitch5entryfromthestack:
C3(su)->clear switch member 5
unit Specifiestheunitnumberoftheswitch.