Switch User Manual

Configuring IRDP
SecureStack C3 Configuration Guide 20-37
Configuring IRDP
Purpose
ToenableandconfiguretheICMPRouterDiscoveryProtocol(IRDP)onaninterface.Thisprotocol
enablesahosttodeterminetheaddressofarouteritcanuseasadefaultgateway.Itisdisabledby
default.
Commands
ip irdp enable
UsethiscommandtoenableIRDPonaninterface.ThenoformofthiscommanddisablesIRDPon
aninterface.
Syntax
ip irdp enable
no ip irdp enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableIRDPontheVLAN1interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip irdp enable
For information about... Refer to page...
ip irdp enable 20-37
ip irdp maxadvertinterval 20-38
ip irdp minadvertinterval 20-38
ip irdp holdtime 20-39
ip irdp preference 20-39
ip irdp broadcast 20-40
show ip irdp 20-40