Switch User Manual

ip rip enable
SecureStack C3 Configuration Guide 20-3
Mode
Globalconfiguration:C3(su)‐>router(Config)#
Usage
YoumustexecutetherouterripcommandtoenabletheprotocolbeforecompletingmanyRIP‐
specificconfigurationtasks.Fordetailsonenablingconfigurationmodes,refertoTable 18‐2in
“EnablingRouterConfigurationModes”onpage18‐2.
Example
ThisexampleshowshowtoenableRIP:
C3(su)->router#configure
C3(su)->router(Config)#router rip
C3(su)->router(Config-router)#
ip rip enable
UsethiscommandtoenableRIPonaninterface.ThenoformofthiscommanddisablesRIPonan
interface:Bydefault,RIPisdisabledonallinterfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableRIPontheVLAN1interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip rip enable
distance
UsethiscommandtoconfiguretheadministrativedistanceforRIProutes.Thenoformofthis
commandresetsRIPadministrativedistancetothedefaultvalueof120.
Syntax
distance weight
no distance [weight]