Switch User Manual

show interface tunnel
SecureStack C3 Configuration Guide 19-11
Example
ThisexamplesetsthetunnelmodetoIPv6overIPv4.
C3(su)->router(Config)# interface tunnel 1
C3(su)->router(Config-if(Tnnl 1))#
C3
(su)->router(Config-if(Tnnl 1))# tunnel mode ipv6ip
show interface tunnel
Thiscommanddisplaysinformationaboutaconfiguredtunnelinterface.
Syntax
show interface tunnel tunnel-id
Parameters
Defaults
None.
Mode
Routerglobalconfiguration:C3(su)‐>router(Config)#
Routerprivilegedexec:C3(su)‐>router#
Usage
Usethiscommandtodisplaygeneralinterfaceinformation.RefertoinChapter 22,IPv6 
Configurationforadescriptionoftheshowipv6interfacetunnelcommand.
Example
Thisexampleshowstheoutputofthiscommand.
C3(su)->router(Config)#show interface tunnel 1
Tunnel 1 is Operationally DOWN
The name of this device is Tunnel 1
The MTU is 1480 bytes
tunnel‐id Specifiesthetunnelforwhichtodisplayinformation.