Switch User Manual

tunnel destination
19-10 IP Configuration
tunnel destination
ThiscommandspecifiestheIPv4destinationtransportaddressofthetunnel.
Syntax
tunnel destination ipv4-addr
no tunnel destination
Parameters
Defaults
None.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(Config‐if(Tnnl1))#
Usage
ThenoformofthiscommandremovesthedestinationIPv4addressforthetunnelinterfacebeing
configured.
Example
ThefollowingexampleconfiguresthedestinationIPv4addressfortunnel1.
C3(su)->router(Config)# interface tunnel 1
C3(su)->router(Config-if(Tnnl 1))#
C3
(su)->router(Config-if(Tnnl 1))# tunnel destination 192.168.10.20
tunnel mode
Thiscommandspecifiesthemodeofthetunnelinterface.
Syntax
tunnel mode ipv6ip
no tunnel mode ipv6ip
Parameters
Defaults
None.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(Config‐if(Tnnl1))#
Usage
Thenoformofthiscommandremovesthemodeofthetunnel.
ipv4‐addr TheIPv4destinationaddressofthetunnel.
ipv6ip SpecifiesthatthetunnelmodeisIPv6overIPv4