Switch User Manual

set dhcp conflict logging
SecureStack C3 Configuration Guide 16-5
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesaddressallocationforBOOTPclients.
C3(rw)->set dhcp bootp enable
set dhcp conflict logging
Usethiscommandtoenableconflictlogging.Bydefault,conflictloggingisenabled.Usetheclear
dhcpconflictloggingcommandtodisableconflictlogging.
Syntax
set dhcp conflict logging
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesDHCPconflictlogging.
C3(rw)->set dhcp conflict logging
show dhcp conflict
Usethiscommandtodisplayconflictinformation,foroneaddressoralladdresses.
Syntax
show dhcp conflict [address]
Parameters
Defaults
Ifnoaddressisspecified,conflictinformationforalladdressesisdisplayed.
address [Optional]Specifiestheaddressforwhichtodisplayconflictinformation.