Switch User Manual

set nodealias
SecureStack C3 Configuration Guide 14-41
----------- ----------- ------------ ------
ge.2.1 16 0 Enable
ge.2.2 47 0 Enable
ge.2.3 47 2 Enable
ge.2.4 47 0 Enable
ge.2.5 47 0 Enable
ge.2.6 47 2 Enable
ge.2.7 47 0 Enable
ge.2.8 47 0 Enable
ge.2.9 4000 1 Enable
Table 14‐8providesanexplanationofthecommandoutput.
set nodealias
Usethiscommandtoenableordisableanodealiasagentononeormoreports,orsetthe
maximumnumberofaliasentriesstoredperport.
Syntax
set nodealias {enable | disable | maxentries maxentries} port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Uponpacketreception,nodealiasesaredynamicallyassignedtoportsenabledwithanalias
agent,whichisthedefaultsettingonSecureStackC3devices.Nodealiasescannotbestatically
created,butcanbedeletedusingthecommand“clearnodealiasconfig”(page 14‐42).
Table 14-8 show nodealias config Output Details
Output Field What It Displays...
Port Number Port designation.
Max Entries Maximum number of alias entries configured for this port.
Used Entries Number of alias entries (out of the maximum amount configured) already used by
this port.
Status Whether or not a node alias agent is enabled (default) or disabled on this port.
enable|disable Enables ordisablesanodealiasagent.
maxentriesmaxentries Setthemaximumnumberofaliasentriesstoredperport.Validrange
is0to4096.Thedefaultvalueis32.
port‐string Specifiestheport(s)onwhichtoenable/disablenodealiasagentorset
amaximumnumberofstoredentries.