Switch User Manual

show sntp interface
SecureStack C3 Configuration Guide 14-37
SNTP-Server Precedence Status
-------------------------------------------
192.255.255.254 2 Active
show sntp interface
Usethiscommandtodisplaytheint erfaceusedforthesourceIPaddressoftheSNTPclient.
Syntax
show sntp interface
Parameters
None.
Defaults
None.
Mode
Switchmode,read‐only.
Example
Thisexampledisplaystheoutputofthiscommand.Inthiscase,theIPaddressassignedto
loopbackinterface1willbeusedasthe sourceIPaddressoftheSNTPclient.
C3(rw)->show sntp interface
loopback 1 192.168.10.1
set sntp interface
UsethiscommandtospecifytheinterfaceusedforthesourceIPaddressoftheSNTPclient.
Syntax
set sntp interface {loopback loop-ID | vlan vlan-ID}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
loopbackloop‐ID Specifiestheloopbackinterfacetobeused.Thevalueofloop‐IDcan
rangefrom0to7.
vlanvlan‐ID SpecifiestheVLANinterfacetobeused.Thevalueofvlan‐IDcanrange
from1to4093.