Switch User Manual

set sntp poll-interval
SecureStack C3 Configuration Guide 14-33
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoremovetheserveratIPaddress10.21.1.100 fromtheSNTPserverlist:
C3(su)->clear sntp server 10.21.1.100
set sntp poll-interval
UsethiscommandtosetthepollintervalbetweenSNTPunicastrequests.
Syntax
set sntp poll-interval value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosettheSNTPpollintervalto64seconds:
C3(su)->set sntp poll-interval 6
clear sntp poll-interval
UsethiscommandtoclearthepollintervalbetweenunicastSNTPrequests.
Syntax
clear sntp poll-interval
Parameters
None.
Defaults
None.
value Thepollintervalis2tothepowerofvalueinseconds,wherevaluecanrange
from6to10.