Switch User Manual

clear logging server
14-4 Logging and Network Management
Defaults
Ifip‐addrisnotspecified,an entryintheSyslogservertablewillbecreatedwiththespecified
indexnumberandamessagewilldisplayindicatingthatnoIPaddresshasbeenassigned.
Ifnotspecified,facility,severityandportwillbesettodefaultsconfiguredwiththesetlogging

defaultcommand(“setloggingdefault”onpage 14‐5).
Ifstateisnotspecified,the serverwillnotbeenabledordisabled.
Mode
Switchcommand,read‐write.
Example
ThiscommandshowshowtoenableaSyslogserverconfigurationforindex1,IPaddress
134.141.89.113,facilitylocal4,severitylevel3onport514:
C3(su)->set logging server 1 ip-addr 134.141.89.113 facility local4 severity 3
port 514 state enable
clear logging server
UsethiscommandtoremoveaserverfromtheSyslogservertable.
Syntax
clear logging server index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThiscommandshowshowtoremovetheSyslogserverwithindex1fromtheservertable:
C3(su)->clear logging server 1
show logging default
UsethiscommandtodisplaytheSyslogserverdefaultvalues.
Syntax
show logging default
Parameters
None.
index Specifiestheservertableindexnumberfortheservertoberemoved.
Validvaluesare1‐8.