Switch User Manual

SecureStack C3 Configuration Guide 1-1
1
Introduction
ThischapterprovidesanoverviewoftheSecureStackC3’suniquefeaturesandfunctionality,an
overviewofthetasksthatmaybeaccomplishedusingtheCLIinterface,anoverviewofwaysto
managetheswitch,factorydefaultsettings,andinformationabouthowtousetheCommandLine
Interfacetoconfiguretheswitch.
SecureStack C3 CLI Overview
TheEnterasysNetworksSecureStackC3CLIinterfaceallowsyoutoperformavarietyofnetwork
managementtasks,includingthefollowing:
•UseCLIcommandstoperformnetwork managementandswitchconfigurationoperations.
• Downloadanewfirmwareimage.
• AssignIPaddressandsubnetmask.
•Selectadefaultgateway.
•EstablishandmanageVirtualLocalAreaNetworks
(VLANs).
•Establishandmanagepolicyprofilesandclassifications.
•Establishandmanagepriorityclassification.
• ConfigureIPv4routingandroutingprotocols.
• ConfigureIPv6routingandroutingprotocols,includingOSPFv3.
• Configuresecurityprotocols,including802.1XandRADIUS,SSHv2,PWA,MAClocking,and
MACauthentication.
• Configureaccesscontrollists(ACLs).
Switch Management Methods
TheSecureStackC3switchcanbemanagedusingthefollowingmethods:
•LocallyusingaVTtypeterminalconnectedtotheconsoleport.
• RemotelyusingaVTtypetermina lconnectedthroughamodem.
For information about... Refer to page...
SecureStack C3 CLI Overview 1-1
Switch Management Methods 1-1
Factory Default Settings 1-2
Using the Command Line Interface 1-6