Switch User Manual

clear garp timer
SecureStack C3 Configuration Guide 10-25
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thesettingofthesetimersiscriticalandshouldonlybechangedby personnelfamiliarwiththe
802.1Qstandardsdocumentation,whichisnotsuppliedwiththisdevice.
Examples
ThisexampleshowshowtosettheGARPjointimervalueto100centisecondsforallports:
C3(su)->set garp timer join 100 *.*.*
Thisexampleshowshowtosettheleavetimervalueto300centisecondsforallports:
C3(su)->set garp timer leave 300 *.*.*
Thisexampleshowshowtosettheleavealltimervalueto20000centisecondsforallports:
C3(su)->set garp timer leaveall 20000 *.*.*
clear garp timer
UsethiscommandtoresetGARPtimersbacktodefaultvalues.
Syntax
clear garp timer {[join] [leave] [leaveall]} port-string
Parameters
Defaults
Atleastoneoptionalparametermustbeentered.
Mode
Switchcommand,read‐write.
leavealltimer‐
value
SetstheGARPleavealltimerincentiseconds(Referto802.1Qstandard.)
port‐string Specifiestheport(s)onwhichtoconfigureGARPtimersettings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 7‐1.
join (Optional)Resetsthejointimerto20centiseconds.
leave (Optional)Resetstheleavetimerto60centiseconds.
leaveall (Optional)Resetstheleavealltimeto1000centiseconds.
port‐string SpecifiestheportorportsonwhichtoresettheGARPtimer(s).