Switch User Manual

set spantree adminedge
9-40 Spanning Tree Configuration
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheedgeportstatusforge.3.2:
C3(su)->show spantree adminedge port ge.3.2
Port
ge.3.2 has a Port Admin Edge of Edge-Port
set spantree adminedge
UsethiscommandtosettheedgeportadministrativestatusonaSpanningTreeport.
Syntax
set spantree adminedge port-string {true | false}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thedefaultbehavioroftheedgeportadministrativestatusbeginswiththevaluesettofalse
initiallyafterthedeviceispoweredup.IfaSpanningTreeBDPUisnotreceivedontheportwithin
afewseconds,thestatussettingchangestotrue.
Example
Thisexampleshowshowtosetge.1.11asanedgeport:
C3(su)->set spantree adminedge ge.1.11 true
clear spantree adminedge
UsethiscommandtoresetaSpanningTreeporttonon‐edgestatus.
Syntax
clear spantree adminedge port-string
port‐string Specifiestheedgeport.Foradetaileddescriptionofpossibleport‐string
values,referto“PortStringSyntaxUsedintheCLI”onpage 7‐1.
true|false Enables(true)ordisables(false)thespecifiedportasaSpanningTreeedge
port.