Switch User Manual

clear spantree autoedge
SecureStack C3 Configuration Guide 9-33
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisableautomaticedgeportdetection:
C3(rw)->set spantree autoedge disable
clear spantree autoedge
Usethiscommandtoresetautomaticedgeportdetectiontothedefaultstateofenabled.
Syntax
clear spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetautomat icedgeportdetectiontoenabled:
C3(rw)->clear spantree autoedge
disable|enable Disablesorenablesautomaticedgeportdetection.