Switch User Manual

Configuring SNMP Target Parameters
SecureStack C3 Configuration Guide 8-23
Configuring SNMP Target Parameters
Purpose
ToreviewandconfigureSNMPtargetparameters.Thiscontrolswhereandunderwhat
circumstancesSNMPnotificationswillbesent.Atargetparameterentrycanbeboundtoatarget
IPaddressallowedtoreceiveSNMPnotificationmessageswiththesetsnmptargetaddr
command(“setsnmptargetaddr”onpage 8 ‐27).
Commands
show snmp targetparams
UsethiscommandtodisplaySNMPparametersusedtogenerateamessagetoatarget.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
Parameters
Defaults
IftargetParamsisnotspecified,entriesassociatedwithalltargetparameterswillbedisplayed.
Ifnotspecified,entriesofallstoragetypeswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySNMPtargetparametersinformation:
C3(su)->show snmp targetparams
--- SNMP TargetParams information ---
Target Parameter Name = v1ExampleParams
Security Name = public
Message Proc. Model = SNMPv1
Security Level = noAuthNoPriv
Storage type = nonVolatile
Row status = active
For information about... Refer to page...
show snmp targetparams 8-23
set snmp targetparams 8-24
clear snmp targetparams 8-25
targetParams (Optional)Displaysentriesforas pecifictargetparameter.
volatile|nonvolatile|
read‐only
(Optional)Displaystargetparameterentriesforaspecificstorage
type.