Switch User Manual

set lldp port network-policy
6-30 Discovery Protocol Configuration
set lldp port network-policy
UsethiscommandtoconfigureLLDPnetworkpoliciesforasetofapplicationsonaportorrange
ofports.ThepoliciesconfiguredwiththiscommandaresentinLLDPDUsasLLDP‐MED
NetworkPolicyTLVs.MultipleNetworkPolicyTLVscanbesentinasingleLLDPDU.
Syntax
set lldp port network-policy {all | voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming-video |
video-signaling} [state {enable | disable}] [tag {tagged | untagged}]
[vid {vlan-id | dot1p}] [cos cos-value] [dscp dscp-value] port-string
Parameters
all Configuresallapplications.
voice Configuresthevoiceapplication.
voice‐signaling Configuresthevoicesignalingapplication.
Thisapplicationwillnotbeadvertisedifthevoiceapplicationis
configuredwiththesameparameters.
guest‐voice Configurestheguestvoiceapplication.
guest‐voice‐signaling Configurestheguestvoicesignalingapplication.
Thisapplicationwillnotbeadvertisedif
theguest‐voice
applicationisconfiguredwiththesameparameters.
softphone‐voice Configuresthesoftphonevoiceapplication.
video‐conferencing Configuresthevideoconferencingapplication.
streaming‐video Configuresthestreamingvideoapplication.
video‐signaling Configuresthevideosignalingapplication.
Thisapplicationwillnotbeadvertisedifthevideo‐conferencing
applicationisconfiguredwiththesame
parameters.
stateenable|disable (Optional)Enablesordisablesadvertisingtheapplication
informationbeingconfigured.
tagtagged|untagged (Optional)Indicateswhethertheapplicationbeingconfiguredis
usingataggedoruntaggedVLAN.Ifuntagged,boththeVLANID
andtheCoSpriorityfieldsareignoredandonlytheDSCPvalue
hasrelevance.
vidvlan‐id|dot1p (Optional)VLANidentifierfortheport.Thevalueofvlan‐idcan
rangefrom1to4093.
Usedot1pifthedeviceisusingprioritytaggedframes,meaning
thatonlytheIEEE802.1Dprioritylevelissignificantandthe
defaultPVIDoftheingressportis
used.
coscos‐value (Optional)SpecifiestheLayer2prioritytobeusedforthe
applicationbeingconfigured.Thevaluecanrangefrom0to7. A
valueof0representsuse ofthedefaultpriorityasdefinedinIEEE
802.1D.
dscpdscp‐value (Optional)SpecifiestheDSCPvaluetobeusedto
provideDiffserv
nodebehaviorfortheapplicationbeingconfigured.Thevaluecan
rangefrom0to63.Avalueof0representsuseofthedefaultDSCP
valueasdefinedinRFC2475.