Switch User Manual

set lldp port tx-tlv
6-28 Discovery Protocol Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Afteryouconfigurealocationinformationvalue,youmustalsoconfiguretheporttosendthe
LocationInformationTLVwiththesetlldpporttx‐tlvcommand.Thisexampleconfiguresthe
ELINidentifier5551234567onportsge.1.1throughge.1.6andthenconfigurestheportstosend
theLocationInformationTLV.
C3(rw)->set lldp port location-info 5551234567 ge.1.1-6
C3(rw)->set lldp port tx-tlv med-loc ge.1.1-6
set lldp port tx-tlv
UsethiscommandtoselecttheoptionalLLDPandLLDP‐MEDTLVstobetransmittedin
LLDPDUsbythespecifiedportorports.Usetheshowlldpportlocal‐infocommandtodisplay
thevaluesoftheseTLVsfortheport.
Syntax
set lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-pol] [med-loc] [med-poe]} port-string
Parameters
all AddsalloptionalTLVstotransmittedLLDPDUs.
port‐desc PortDescriptionoptionalbasicLLDPTLV.ValuesentisifDescrobject
definedinRFC2863.
sys‐name SystemNameoptionalbasicLLDPTLV.Valuesentisthe
administrativelyassignednameforthesystem.
sys‐desc SystemDescriptionoptionalbasicLLDPTLV.Valuesentis
sysDescr
objectdefinedinRFC3418.
sys‐cap SystemCapabi litiesoptionalbasicLLDPTLV.Foranetwork
connectivitydevice,valuesentcan bebridgeand/orrouter.
mgmt‐addr ManagementAddressoptionalbasicLLDPTLV.ValuesentisIPv4
addressofhostinterface.
vlan‐id PortVLANIDIEEE802.1ExtensionsTLV.Valuesentis
portVLAN
ID(PVID).
stp SpanningTreeinformationdefinedbyProtocolIdentityIEEE802.1
ExtensionsTLV.IfSTPisenabledontheport,valuesentincludes
versionofprotocolbeingused.
lacp LACPinformationdefinedbyProtocolIdentityIEEE802.1
ExtensionsTLV.IfLACPisenabledontheport,valuesentincludes
versionofprotocolbeingused.