Switch User Manual

set lldp port med-trap
SecureStack C3 Configuration Guide 6-27
Mode
Switchcommand,read‐write.
Example
Thisexampleenablestransmitt ingLLDPtrapsonportsge.1.1throughge.1.6.
C3(rw)->set lldp port trap enable ge.1.1-6
set lldp port med-trap
UsethiscommandtoenableordisablesendinganLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensedontheport(thatis,aremoteendpointdevicehasbeenattachedor
removedfromtheport).
Syntax
set lldp port med-trap {enable | disable} port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleenablestransmitt ingLLDP‐MEDtrapsonportsge.1.1throughge.1.6.
C3(rw)->set lldp port med-trap enable ge.1.1-6
set lldp port location-info
UsethiscommandtoconfigureLLDP‐MEDlocationinformationonaportorrangeofports.
Currently,onlyEmergencyCallServices(ECS)EmergencyLocationIdentificationNumber(ELIN)
issupported.
Syntax
set lldp port location-info elin elin-string port-string
Parameters
enable EnablestransmittingLLDP‐MEDtrapsonthespecifiedports.
disable DisablestransmittingLLDP‐MEDtrapsonthespecifiedports.
port‐string Specifiestheportorrangeofportstobeaffected.
elin SpecifiesthattheECSELINdataformatistobeused.
elin‐string Specifiesthelocationidentifier.Valuecanbefrom10to25numerical
characters.
port‐string Specifiestheportorrangeofportstobeaffected.