Switch User Manual

set lldp med-fast-repeat
SecureStack C3 Configuration Guide 6-25
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexamplesetstheminimumintervalbetweenLLDPtrapsto10seconds.
C3(rw)->set lldp trap-interval 10
set lldp med-fast-repeat
NetworkconnectivitydevicestransmitonlyLLDPTLVsinLLDPDUsuntiltheydetectthatan
LLDP‐MEDendpointdevicehasconnectedtoaport.Atthatpoint,thenetworkconnectivity
devicestartssendingLLDP‐MEDTLVsatafaststartrateonthatport.Usethiscommandtosetthe
numberof
successiveLLDPDUs(withLLDP‐MEDTLVs)tobesentforonecompletefaststart
interval.
Syntax
set lldp med-fast-repeat count
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexamplesetsthenumberoffaststartLLDPDUstobesentto4.
C3(rw)->set lldp med-fast-repeat 4
frequency SpecifiestheminimumtimebetweenLLDPtraptransmissions,in
seconds.Thevaluecanrangefrom5to3600seconds.Thedefault
valueis5seconds.
count SpecifiesthenumberoffaststartLLDPDUstobesentwhenan
LLDP‐MEDendpointdeviceisdetected.Valuecanrangefrom1to
10.Defaultis3.