Switch User Manual

set lldp hold-multiplier
6-24 Discovery Protocol Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetransmitintervalto20seconds.
C3(rw)->set lldp tx-interval 20
set lldp hold-multiplier
Usethiscommandtosetthetime‐to‐livevalueusedinLLDPframessentbythisdevice.Thetime‐
to‐liveforLLDPDUdataiscalculatedbymultiplyingthetransmitintervalbytheholdmultiplier
value.
Syntax
set lldp hold-multiplier multiplier-val
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetransmitintervalto20secondsandtheholdmultiplierto5,whichwill
configureatime‐to‐liveof100tobeusedintheTTL fieldintheLLDPDUheader.
C3(rw)->set lldp tx-interval 20
C3(rw)->set lldp hold-multiplier 5
set lldp trap-interval
UsethiscommandtosettheminimumintervalbetweenLLDPnotificationssentbythisdevice.
LLDPnotificationsaresentwhenaremotesystemchangehasbeendetected.
Syntax
set lldp trap-interval frequency
multiplier‐val Sp ecifiesthemultipliertoapplytothetransmitintervaltodetermine
thetime‐to‐livevalue.Valuecanrangefrom2to10.Defaultvalueis4.