Switch User Manual

clear system hostprotect
SecureStack C3 Configuration Guide 3-57
Parameters
Defaults
Thisfeatureisdisabledbydefault.
Mode
Switchcommand,read‐write.
Usage
Hostprotectuseshardwareresourcesthatarealsousedforpriorityqueues(see“Configuring
PrioritytoTransmitQueueMapping”onpage12‐4),soifhostprotectisenabled,priorityqueues
arelimited.
Atboottime,ifmorethantwopriorityqueuemappingsaredefined,inadditiontothedefault
mapping,hostprotect
willbedisabled.
Atruntime,ifhostprotectifenabled,andyouattempttodefinemorethantwopriorityqueue
mappings(withthesetportpriority‐queuecommand),thesetwillfailandawarningmessage
willbedisplayed.
Atruntime,ifmorethantwopriorityqueuemappingsexist,and
youattempttoenable
hostprotectwiththiscommand,thesetwillfailandawarningmessagewillbedisplayed.
Changingthehostprotectstatusrequiresaresetoftheswitchorstackofswitches.
Example
Thisexampledisableshostprotect.
C3(rw)->set system hostprotect disable
Changes in the host protect mode will require resetting this stack.
Are you sure you want to continue? (y/n)y
clear system hostprotect
Usethiscommandtoreturnthehostprotectstatustothedefaultofenabled.
Syntax
clear system hostprotect
Parameters
None.
Defaults
Thedefaultstateisenabled.
Mode
Switchcommand,read‐write.
enable Enableshostprotectmode.
disable Disableshostprotectmode.