Switch User Manual

Using and Configuring WebView
3-52 Basic Configuration
•UseclearconfigtoclearconfigurationparameterswithoutclearingstackunitIDs.This
commandWILLNOTclearstackparametersandavoidstheprocessofre‐numberingthe
stack.
•Useclearconfigallwhenitisnecessarytoclearallconfigurationparameters,includingstack
unitIDs(ifapplicable)andswitchpriorityvalues.
•Use
theclearipaddresscommandtocleartheIPaddress.
Configurationparametersandstackinginformationcanalsobeclearedonthemasterunitonlyby
selectingoption10(restoreconfigurationtofactorydefaults)fromthebootmenuonswitch
startup.Thisselectionwillleavestackingprioritiesonallotherunits,if
applicable.
Example
Thisexampleshowshowtoclearconfigurationparameters(includingstackingparameters,if
applicable):
C3(su)->clear config all
Using and Configuring WebView
Purpose
Bydefault,WebView(TheEnterasysNetworksembeddedwebserverforswitchconfiguration
andmanagementtasks)isenabledonTCPportnumber80ontheSecureStackC3switch.Youcan
verifyWebViewstatus,andenableordisableWebViewusingthecommandsdescribedinthis
section.WebViewcanalsobesecurelyusedover
SSLport443,ifSSLisenabledontheswitch.By
default,SSLisdisabled.
TouseWebView ,typetheIPaddressoftheswitchinyourbrowser.TouseWebViewoverSSL,
typeinhttps://thentheIPaddressoftheswitch.Forexample,https://172.16.2.10.
Commands
show webview
UsethiscommandtodisplayWebViewstatus.
Syntax
show webview
Parameters
None.
For information about... Refer to page...
show webview 3-52
set webview 3-53
show ssl 3-53
set ssl 3-54