Switch User Manual

show snmp persistmode
3-40 Basic Configuration
show snmp persistmode
Usethiscommandtodisplaytheconfigurationpersistencemodesetting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Bydefault,themodeissetto“autosave,”whichautomatica llysavesconfigurationchangesat
specificintervals.Ifthemodeissetto“manual,”configuration commandsareneverautomatically
saved.Inordertomakeconfigurationchangespersistentwhenthemodeismanual,thesave
configcommandmustbeissuedasdescribed
in“Configuration PersistenceMode”onpage3‐39.
Example
Thisexampleshowshowtodisplaytheconfiguration persistencemodesetting.Inthiscase,
persistencemodeissetto“manual”,whichmeansconfigurationchangesarenotbeing
automaticallysaved.
C3(su)->show snmp persistmode
persistmode is manual
set snmp persistmode
Usethiscommandtosettheconfigurationpersistencemode,whichdetermineswhetheruser‐
definedconfigurationchangesaresavedautomatically,orrequireissuingthesaveconfig
command.See“ConfigurationPersistenceMode”onpage3‐39formoreinformation.
Syntax
set snmp persistmode {auto | manual}
clear tftp timeout 3-47
set tftp retry 3-48
clear tftp retry 3-48
For information about... Refer to page...