Network Card User Manual

58 RiverMaster Administrator’s Guide
Routing Chapter 3
Configuring an ANG-3000/7000
To configure OSPF properties for the ANG, perform the following steps.
1 Perform the steps in “Setting Routing Protocol Parameters” on
page 55 to access OSPF properties.
The OSPF Configuration window appears as shown in Figure 33.
Figure 33 OSPF Routing Protocol Configuration
2
Type the area ID shared by the ANG and routers within the subnet in
theOSPFAreaIDfields.
3 Type the IP address for the Trusted interface in the OSPF Router ID
fields.
AS Export
Limit
Specifies how many autonomous systems are
generated and exported each time.
100
Interface
Priority
Determines the ANG’s priority for becoming
the designated router in the area.
0 (the ANG cannot
be the designated
router)
Table 4 Fixed OSPF Parameters
Parameter Meaning Fixed Value