Network Card User Manual

RiverMaster Administrator’s Guide 57
Chapter 3 Routing
Configuring an ANG-3000/7000
5 Repeat Step 3 and Step 4 for each gateway required.
6 Do one of the following:
– Click Apply to save your changes.
– Click Cancel to close the window without saving your changes.
– Click Reset to return the RIP parameters to their default settings.
SettingOSPFProperties
Using the RiverMaster, you can define the following OSPF parameters:
H Area ID shared by the routers and the ANG.
H Router ID that identifies the ANG to other devices in the OSPF area.
The default value for this address is the IP address assigned to the
Trusted interface on the ANG.
H Authentication algorithm used to accept or reject routing table
updates from other routers.
To route packets for remote clients using OSPF, the ANG also uses a set of
fixed operating parameters. Table 4 lists these fixed OSPF parameters, which
use common default values and cannot be changed.
Table 4 Fixed OSPF Parameters
Parameter Meaning Fixed Value
Preference Determines how OSPF routes compete with
routes from other protocols (such as RIP) in
the ANG’s routing table. The route with the
lowest preference value is selected.
150
Cost Used when exporting a non-OSPF route from
the ANG’s routing table into OSPF as an
autonomous system (AS).
1
Type Indicates which type of autonomous systems
that routes exported from the ANG’s routing
table become.
Type 1 AS
AS Export
Interval
Specifies how often autonomous system link
advertisements are generated and exported.
Once per second